Tool
| Parameter |
Meaning |
Default value |
Units |
| Tool diameter |
Diameter of a milling tool |
0.3 |
mm |
| Speed |
Value of speed parameter passed to the machine controller for milling operation (PWM width of control pulse in case of Cirqoid machines) |
1390 |
ms |
Feed
| Parameter |
Meaning |
Default value |
Units |
| X and Y axes |
Default feed on X and Y axes (speed with which tool moves during milling) |
300 |
mm/min |
| Z axis |
Default feed on Z axis (speed with which tool moves descending to working height) |
200 |
mm/min |
| Arcs |
Feed for arcs specified as a percent from Feed XY |
50 |
% |
Heights
| Parameter |
Meaning |
Default value |
Units |
| Clearance |
Default value of clearance – the height above the board, the program uses to move the tool between traces |
5 |
mm |
| Safety height |
Default value of safety height – the height above the board, where tool switches from rapid descend to feed on Z axis, when descending to working level |
2 |
mm |
| Z offset |
Z offset, which is used as a starting point in Z offset establishing procedure |
|
mm |
| Working height |
The depth of tool engagement in laminate |
-0.05 |
mm |
All heights are specified in work coordinate system (i.e. taking into account Z offset).
Rub-out
| Parameter |
Meaning |
Default value |
Units |
| Skip by default |
If this checkbox is selected, Continue button on insulation milling screen would skip rub-out and go directly to the next screen |
Selected |
|
| Overlap |
Overlap between rub out passes |
20 |
% |
| Initial offset |
Offset the rub out tool will keep away from traces |
0.2 |
mm |